The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it concerns covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re looking forward to the exercise you’ll obtain from using it. Maybe you’re a little relieved to have lastly selected from the various designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that gets back with your new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are very small as they increase from the water surface. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place slowly and on a Swim Spa Cover which is made of individual areas, at varying speeds. So eventually you’ll discover a couple of of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance because you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a various design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately end up in some garbage dump, they developed one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to order today, bookmark this site so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *