The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it concerns covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same reasons a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot harder.
Getting a brand-new swim spa is an amazing event in life. You’re eagerly anticipating the workout you’ll obtain from using it. Maybe you’re a little relieved to have finally made a selection from the various designs you took a look at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets back with your brand-new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely little as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It happens slowly and on a Swim Spa Cover which is made of specific sections, at varying speeds. So eventually you’ll see a couple of of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com came up with a different style for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will ultimately wind up in some garbage dump, they designed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to purchase today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *