The Challenges to Swim Spa Covers

Swim Spas represent special difficulties when it pertains to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, removing and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re eagerly anticipating the exercise you’ll obtain from using it. Possibly you’re a little relieved to have finally selected from the various designs you took a look at. At any rate, you probably weren’t thinking much about the cover you would use.
Normally, the cover that comes home with your new purchase will be a 4 area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as quickly as it is positioned in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are really small as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.

It takes place slowly and on a Swim Spa Cover which is made of specific areas, at varying speeds. So ultimately you’ll observe one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much aid because you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a new design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will ultimately wind up in some landfill, they created one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to purchase today, bookmark this site so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *