The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re anticipating the exercise you’ll receive from using it. Perhaps you’re a little relieved to have actually finally made a selection from the different models you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Typically, the cover that comes home with your new purchase will be a four section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as soon as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are very small as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs gradually and on a Swim Spa Cover which is made of specific sections, at varying speeds. So eventually you’ll notice a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will eventually wind up in some garbage dump, they designed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or break down at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to buy today, bookmark this site so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *