The Challenges to Swim Spa Covers

Swim Spas represent special obstacles when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an amazing occasion in life. You’re eagerly anticipating the workout you’ll receive from using it. Maybe you’re a little relieved to have actually finally made a selection from the various designs you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Usually, the cover that comes home with your brand-new purchase will be a 4 area stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence because as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely small as they increase from the water surface area. They make their way into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.

It happens slowly and on a Swim Spa Cover which is made of specific areas, at varying speeds. So ultimately you’ll see a couple of of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance due to the fact that you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a new design for their Swim Spa Covers
Instead of using numerous foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this website so you can discover it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *