Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting occasion in life. You’re eagerly anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have finally made a selection from the different designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that comes home with your brand-new purchase will be a four area rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style flaw. Integrated in obsolescence since as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are extremely little as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It happens gradually and on a Swim Spa Cover which is made from specific areas, at varying speeds. So ultimately you’ll observe one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will eventually wind up in some land fill, they created one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the cover for it.
If you’re not all set to purchase today, bookmark this site so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *